Magnetic Pick Up MSP6729 Rotate Speed Sensor Sender Ring Gear Teeth 3/8-24UNF-2A With 1 Year Warranty

Part Name: 
Magnetic Pick Up MSP6729 Rotate Speed Sensor Sender Ring Gear Teeth 3/8-24UNF-2A With 1 Year Warranty
Part Number: MSP6729
Description:

• The magnetic speed sensor indicates when ring gear teeth, or other ferrous projections, pass the tip of the sensor.
• Electrical impulses are induced within the coil and sent to the speed control unit. The signal from the magnetic speed Sensor, teeth per second(HZ), is directly proportional to engine speed.
• The magnetic speed sensor is mounted in the ring gear case or flywheel bell housing of the engine.
• The threaded hole for the speed sensor should be perpendicular to the centerline of the crankshaft and centered over the ring gear teeth.
• A spot face should be present to provide a flat surface on which to anchor the locknut.
• With the engine stopped, screw the speed senor in until it touches a gear tooth, then back it out 3/4 of a turn and secure it with the locknut.
• Any ferrous gear may be used as long as the frequency and amplitude of the resulting signal meet the speed control unit specifications
• The wire leads should be twisted for their entire length from the magnetic speed sensor to the control unit.
• The leads may need shielding if they are longer than 10 ft. (3m), or if external interference is present.
• Do not connect either of the speed sensor leads to anything but the speed control unit used. The shield should not be connected at the speed sensor end.